- The film-forming preparation is used to isolate acrylic from plaster
- The preparation does not contain formaldehyde
- Has bacteriostatic effect
- It allows easy separation of gypsum molds after polymerization
- It creates a very thin and smooth film, which guarantees maximum fidelity
- It can be used to isolate gypsum from acrylic resins and gypsum from gypsum
IZOL-GIPS
Description
Product destination:
Izol-gips is intended for separate gypsum mold surfaces from methacrylate mass.
Directions for use:
The gypsum mold should be thoroughly rinsed with a stream of boiling water to completely remove the remains of model wax. This cleaning should be done very carefully, because it depends on the easiness of spreading the separating preparation and its proper adhesion to the mold surface.
Pour isolated gypsum into a small vessel and use a soft brush to coat the surface of the gypsum mold previously heated to 40 ° C. After a few minutes, apply the layer of plaster again. After drying, you can start forming the methacrylic dough.
Attention! The brush that was used to cover the mold should not be immersed directly in the bottle with gypsum isolate or the residue should not be drained so as not to contaminate the preparation and avoid its gelation in the package.
Contraindications:
Do not use after the expiry date.
Precautions:
Wear protective gloves, protective clothing, eye protection and face protection when working with the preparation. IF ON SKIN: Wash with plenty of water. If skin irritation occurs: Get medical advice / attention. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue to rinse. If eye irritation persists, get medical advice / attention.
Do not use the device if any signs of damage are observed. Expiry date does not change after opening under condition of tightly closing after each use.
The storage conditions:
Store in a dry place in the original tightly closed container, up to 25ºC. Protect from moisture.
The term of validity:
The expiry date can be found on the immediate packaging.
Handling packaging after the product:
Used packaging should be disposed of in accordance with applicable regulations.
Composition:
Sodium alginate, dye E124.
Direct packaging:
HDPE bottle containing 1 kg of product.
FIRMLY CLOSE AFTER EACH USE
KEEP OUT OF THE REACH AND SIGHT OF CHILDREN
